Write, answer, and forward

The following commands are prepared for writing, replying, and forwarding a message.

`w'

Write a message. A new draft is prepared in Draft mode.

`a'

Answer to this message. A new draft is prepared in Draft mode. Mew automatically decides To: and Cc:.

`A'

Answer to this message. A new draft is prepared in Draft mode. Mew automatically decides To: and Cc: and cites the body.

`f'

Forward this message to a third person. A new draft is prepared in Draft mode and this message is automatically attached.

`F'

Forward messages marked with `@' to a third person. A new draft is prepared in Draft mode and this message is automatically attached. For more information, refer to See section Multiple `@'.

If an error message returns, let's give one more try with the following commands.

`E'

Edit this message again to send. Or edit this rfc822 part typically included MIME-encapsulated error message. In the +draft folder, it just edits the message. Otherwise, copy the message to the +draft folder, then edit.

`M-e'

Edit an old fashioned error message in which the original message is encapsulated after "----- Original message follows -----".